Pulsar Y621 How To Use

Analogue watches

Hide thumbs Also See for Y621:

Table of Contents

Download this manual

ANALOGUE WATCHES

SCREW DOWN CROWN

Unlocking the crown

1 Turn Crown counterclockwise until you no

longer feel the threads turning.

2 Crown can be pulled out.

Locking the crown

1 Push Crown back in to normal position.

2 Turn Crown clockwise while pressing it lightly

until tight.

* When using the watch in water:

Before using the watch in water, be sure the crown is screwed in completely.

Do not operate the crown when the watch is wet or in water.

[for models with screw down crown]

Table of Contents

Do you have a question about the Y621 and is the answer not in the manual?

Page 1 ANALOGUE WATCHES SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
Page 2 5 Turn to set the time. 6 Push back in to normal position. * If the watch is worn daily, PULSAR's automatic mechanism will wind the mainspring automatically through normal wrist movement. TIME/CALENDAR SETTING FOR MODELS WITH DAY AND DATE CALENDAR...
Page 3 A.M. or P.M. period. If the calendar changes, the time is set for We recommend that you contact an AUTHORIZED PULSAR DEALER for the A.M. period. If it does not change, the time is set for the P.M. period.
Page 4 Loss/gain (monthly rate) is less than 15 seconds (20 seconds for some We recommend that you wear a PULSAR Diver’s dental contact with splashes of water or rain, but it calibres) at normal temperature range (5°C ~ 35°C)(41°F ~ 95°F).
Page 5 Care should also be taken on diving into water. checked by an AUTHORIZED this may cause damage. PULSAR DEALER or SER VICE TEMPERATURES CENTER to ensure that the case, crown, CHEMICALS may cause battery leakage or shorten buttons, gasket and crystal seal remain intact.