Table of Contents
Advertisement
SCREW DOWN CROWN
Unlocking the crown
1 Turn Crown counterclockwise until you no
longer feel the threads turning.
2 Crown can be pulled out.
Locking the crown
1 Push Crown back in to normal position.
2 Turn Crown clockwise while pressing it lightly
until tight.
* When using the watch in water:
Before using the watch in water, be sure the crown is screwed in completely.
Do not operate the crown when the watch is wet or in water.
ANALOGUE WATCHES
[for models with screw down crown]
Advertisement
Table of Contents
Related Manuals for Pulsar Pulsar ANALOGUE
Summary of Contents for Pulsar Pulsar ANALOGUE
- Page 1 ANALOGUE WATCHES SCREW DOWN CROWN [for models with screw down crown] Unlocking the crown 1 Turn Crown counterclockwise until you no longer feel the threads turning. 2 Crown can be pulled out. Locking the crown 1 Push Crown back in to normal position. 2 Turn Crown clockwise while pressing it lightly until tight.
- Page 2 HOW TO START THE MECHANICAL WATCH (Cal. Y621) To initially start your watch, swing it from side to side in a horizontal arc for about 30 seconds. * If the watch is worn daily, PULSAR’s automatic mechanism will wind the mainspring automatically through normal wrist movement.
- Page 3 2 Turn to show the previous day’s date. 3 Pull out to the second click. 4 Turn until the desired date appears. * Turn Crown to advance Hour and Minute hands. 5 Turn to set the time. 6 Push back in to normal position. TIME/CALENDAR SETTING FOR MODELS WITH DAY AND DATE CALENDAR CROWN 1 Pull out to the first click.
- Page 4 * Turn Crown to advance Hour and Minute hands. 6 Turn to set the time. 7 Push back in to normal position. Notes on time setting: When setting Minute hand of a quartz watch, advance it a few minutes ahead and then turn it back to the exact time.
- Page 5 As the battery is inserted at the factory to check the function and performance of the watch, its actual life once in your possession may be less than the specified period. When the battery expires, be sure to replace it as soon as possible to prevent any malfunction.
- Page 6 CAUTION The battery is not rechargeable. Never attempt to recharge it, as this may cause battery leakage or damage to the battery. Loss/gain (monthly rate) is less than 15 seconds (20 seconds for some calibres) at normal temperature range (5 C ~ 35 C)(41 F ~ 95 F).
- Page 7 WATER RESISTANCE Non-water resistant • If the watch becomes wet, have it checked by an AUTHORIZED PULSAR DEALER or SERVICE CENTER. Water resistant 5/10/15/20 bar • Before using in water, be sure the crown is pushed in completely. • Do not operate the crown when the watch is wet or in water. If used in sea water, rinse the watch in fresh water and dry it bar WR completely.
- Page 8 * Pressure in bar is a test pressure and should not be considered as corresponding to actual diving depth since swimming movement tends to increase the pressure at a given depth. Care should also be taken on diving into water. ** We recommend that you wear a PULSAR Diver’s Watch for scuba diving.
- Page 9 PERIODIC CHECK SHOCKS & VIBRATION Light activities will not It is recommended that the affect your watch, but be watch be checked once 2 - 3 careful not to drop your every 2 to 3 years. Have Years watch or hit it against hard your watch checked by an surfaces, as this may AUTHORIZED PULSAR...