Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Pulsar 7T62
Summary of Contents for Pulsar 7T62
- Page 1 CAL. 7T62, YM62 ALARM & CHRONOGRAPH TIME/CALENDAR ● Hour, minute and small second hands ● Date displayed in numerals STOPWATCH ● Measures up to 60 minutes in 1/5 second increments. ● Split time measurement SINGLE-TIME ALARM ● Rings only once at a designated time within the coming 12...
-
Page 2: Screw Down Crown
SCREW DOWN CROWN DISPLAY AND CROWN/BUTTONS [for models with screw down crown] Unlocking the crown STOPWATCH STOPWATCH minute hand 1/5-second hand 1 Turn Crown counterclockwise until you no Minute hand longer feel the threads turning. Hour hand 2 Crown can be pulled out. Locking the crown CROWN 1 Push Crown back in to normal position. -
Page 3: Setting The Time And Adjusting The Stopwatch Hand Position
1) MAIN TIME SETTING SETTING THE TIME AND ADJUSTING THE STOPWATCH HAND POSITION Hour hand Minute hand Turn to set the hour and ● This watch is so designed that the following are all made with the crown at the CROWN minute hands. - Page 4 Hour hand Minute hand Press repeatedly to set STOP- STOPWATCH STOPWATCH Press repeatedly to set ALARM WATCH minute hand to the “0” 1/5-second minute hand hands to the time indicated by hand position. the main time hands. * The hand moves quickly if button * ALARM hands move quickly if B is kept pressed.
-
Page 5: Setting The Date
SETTING THE DATE ● ALARM and STOPWATCH hands can be readjusted in the following order ● Before setting the date, be sure to set the main time. by pressing button A for 2 seconds. ALARM STOPWATCH STOPWATCH CROWN hands minute hand 1/5-second hand ➠... - Page 6 ● Before using the stopwatch, be sure to check that the crown is set at the normal STOPWATCH position and that the STOPWATCH hands are reset to the “0” position. * If the STOPWATCH hands do not return to the “0” position when the stopwatch ●...
-
Page 7: Single-Time Alarm
SINGLE-TIME ALARM Push back in to normal CROWN position. ● The alarm can be set to ring only once at a designated time within the coming 12 hours. * The alarm is automatically ● The alarm time can be set in one minute increments. engaged. - Page 8 “90” (tachymeter scale figure) x 2 (km or mile) = 180 km/h or mph TACHYMETER “90” (tachymeter scale figure) x 0.5 (km or mile) = 45 km/h or mph [for models with tachymeter scale on the dial] To measure the hourly average speed of a vehicle To measure the hourly rate of operation [ Ex.
-
Page 9: Notes On Operating The Watch
STOPWATCH NOTES ON OPERATING THE WATCH ● Restart and stop of the stopwatch can be repeated by pressing button A. ● Measurement and release of split time can be repeated by pressing button B. SETTING THE TIME AND ADJUSTING THE STOPWATCH HAND POSITION SINGLE-TIME ALARM ●... -
Page 10: Battery Change
* The watch remains accurate while the small second hand is moving at two-second BATTERY CHANGE intervals. Battery life : Approx. 3 years WARNING Battery : SEIKO SR927W Years ● Do not remove the battery from the watch. ● If it is necessary to take out the battery, keep it out of the reach of ●... -
Page 11: To Preserve The Quality Of Your Watch
● Water resistance (10 bar/15 bar/20 bar)* to actual diving depth since swimming movement tends to increase the have it checked by an AUTHORIZED PULSAR If “WATER RESISTANT 10 BAR”, pressure at a given depth. Care should also be taken on diving into water. -
Page 12: Periodic Check
2 - 3 careful not to drop your Years your watch checked by an watch or hit it against hard AUTHORIZED PULSAR surfaces, as this may DEALER or SERVICE CENTER to cause damage. ensure that the case, crown, buttons, CHEMICALS gasket and crystal seal remain intact.