Polaris 2003 Genesis i Owner's Safety And Maintenance Manual page 55

Pre-Operation Inspection
Fuel/Water Separator
The fuel/water separator is located either
under the front compartment door behind
the storage bucket on the starboard side or
inside the engine compartment. Inspect
the separator only when the watercraft is
out of the water.
1.Deck
2.Fuel/Water Separator
NOTE: The fuel/water separator is integral to the fuel pump module
on Direct Injected models. It is not serviceable.
1. Visually inspect the fuel/water separator bowl (1).
If water is present at the bottom of the bowl, it will
appear as a clear liquid.
2. Turn off the fuel valve and remove the bowl by
turning it counterclockwise. NOTE: Use care to
avoid spilling fuel when removing the bowl. Wipe
up any spills immediately with a shop towel.
3. Empty the bowl and dispose of the fluid properly.
Follow all gasoline handling precautions as outlined
on page 44.
4. Re-install the separator bowl, making sure the o-ring
is in place. Hand tighten securely.
OPERATION
1
2
1
53