Polaris 2003 Genesis i Owner's Safety And Maintenance Manual page 40

FEATURES
Multi-Function Instrument (MFI)
Primary Functions
ON/AUTO: The MFI will automatically "wake-up" when the engine
start button is pressed or alternately by pressing and holding any button
for 1 second.
AUTO OFF: The MFI will return to sleep mode after 5 minutes of
inactivity. While in sleep mode, the clock continues to show time, and
the fuel level, oil level, and the compass rose are displayed. If the
SECURITY LOCK is active, the display will also show "LOCKED."
TACHOMETER: The analog tachometer visually displays the
revolutions per minute (RPM) of the engine in 200 rpm increments
from 0 to 8000 rpm. For more accurate RPM readings, see "DISPLAY"
below.
FUEL GAUGE: Displays fuel level in exact 1/8 tank increments.
Toggles "LOW FUEL" warning and flashes the warning LED when
fuel reaches 1/8 level. Pressing any key will disable the flashing LED
for 15 minutes.
OIL GAUGE: Displays oil level in exact 1/4 tank increments.
Toggles "LOW OIL" warning and flashes the warning LED when oil
reaches 1/4 level. Pressing any key will disable the flashing LED for
15 minutes.
DEPTH GAUGE: (An optional transducer kit is required.) Before
activating the DEPTH GAUGE function, the depth sensor must first be
installed. After installation is complete, press and hold both the 3/8 and
4/9 buttons simultaneously for several seconds to activate the DEPTH
GAUGE function. The display will read "SONAR ON", and the depth
digits under the fuel and oil gauges will display depth in either feet or
meters. If the sensor is not found, the MFI will automatically cancel
the DEPTH GAUGE function. The DEPTH GAUGE will display
water depth below the hull from 0 to 199 feet (0 to 75 meters). The
readout is accurate to approximately 45 mph (70 kph). The display will
flash "- - - -" if tracking is lost. To disable the DEPTH GAUGE, simply
press and hold the 3/8 and 4/9 buttons simultaneously for several
seconds until "SONAR OFF" IS displayed.
CLOCK: The center of the LCD display contains a digital clock. To
set the clock, simply press and hold the "CLOCK SET" button until
the clock digits begin to flash. Each subsequent press of the CLOCK
button advances the time by 1 minute. Pressing and holding the button
will automatically advance the digits more rapidly. Once the intended
time is reached, simply release the button. After 5 seconds, the MFI
will automatically exit the "clock set" mode.
38