Polaris 2003 Genesis i Owner's Safety And Maintenance Manual page 54

OPERATION
Pre-Operation Inspection
Switches/Buttons
1.Lanyard
2.PERCt Reverse (if equipped)
3.Lock Plate
4.PERCt Forward (if equipped)
5.Bilge, Manual Override
6.Start
7.Stop Button
Perform the following checks while the watercraft is in the water:
1. Engage the bilge pump (gray button) to pump water out of the
engine compartment. See page 24.
2. Check the inside of the engine compartment for fuel or water leaks.
Do not operate the watercraft until any leaks have been repaired.
3. Start the engine and let it run for a few seconds. Remove the
lanyard lock plate from the engine shut-off switch to test operation.
The engine should stop immediately. If it doesn't, press the stop
button or pull the choke lever knob out until the engine stops. Do
not ride the watercraft. Have it serviced by an authorized Polaris
dealer before operating it again.
4. If removing the lanyard lock plate successfully stopped the engine
in the previous step, start the engine again and allow it to run for a
few seconds. Depress the engine stop button until the engine stops.
If the engine doesn't stop, pull the choke lever knob out until the
engine stops. Do not ride the watercraft. Have it serviced by an
authorized Polaris dealer before operating it again.
52
5
4
2
1
6, 7
3