Polaris 2003 Genesis i Owner's Safety And Maintenance Manual page 42

FEATURES
Multi-Function Instrument (MFI)
DIRECTION: The lower portion of the analog display contains a
forward/reverse direction indicator. The pointer on the gauge moves in
synchronization with the reverse gate as it is lowered over the jet
nozzle when actuated by the electric thumb switch. The indicator is
useful in establishing a "neutral" position between forward and reverse.
The LED will flash when the reverse gate is not fully forward. Pressing
any key will disable the LED for 5 minutes.
CODE SET MODE: The factory set default security code is "1234",
however, the code may be changed to any 4 digit number. To select
your own code, enter CODE SET mode by pressing and continuing to
hold the LOCK button for several seconds until "CHANGE CODE" is
displayed (the display will first show the lock status, followed by
"ENTER CODE _ _ _ _", and finally "CHANGE CODE". The MFI
will then display "OLD CODE _ _ _ _". Enter the code as if locking or
unlocking the vehicle. If the correct code is entered, the display will
then show "NEW CODE _ _ _ _". Select any 4-digit code. The display
will then read "CONFIRM CODE _ _ _ _". Enter the same code to
confirm your selection. "CODE CONFIRMED" will display for
several seconds if the second entry of the new code matches the first. If
the second code entered does not match the first, "INVALID CODE"
will be displayed and the CODE SET MODE is cancelled.
DISPLAY: Pressing the DISPLAY button toggles the MFI between
NORMAL DISPLAY mode and DIGITAL DISPLAY mode. The lower
display will show VOLTS/DISTANCE/HOURS when in NORMAL
mode, and real-time digital RPM and SPEED when in DIGITAL mode.
When first entering DIGITAL DISPLAY mode, the MFI briefly
displays the last recorded peak RPM and SPEED. While the peak
values are being displayed, holding the DISPLAY button for several
seconds will reset the peak values. Pressing the DISPLAY button while
in DIGITAL DISPLAY mode toggles the display back to the standard
VOLT/DISTANCE/HOURS display.
ENGLISH/METRIC: To change units between English and metric,
press and hold the 1/6 button and the 2/7 button simultaneously for
several seconds. When in metric mode, "km" appears in the distance
meter, and the "MTRS" icon will illuminate in the depth gauge if
activated.
WARNING INDICATIONS: LOW FUEL - 1/8 tank or less of fuel
remaining; LOW OIL: 1/4 tank or less of oil remaining; ENGINE
OVERHEAT - overheated engine; LOW BATTERY - battery voltage
below 10.9 volts; REVERSE indicates reverse has been initiated;
CHECK ENGINE (DI models) - indicates a warning condition from
the computer engine management system.
40