Advertisement
Quick Links
This appliance may be installed as an OEM installation in a manufactured
(mobile) home and must be installed in accordance with the manufacturer's
instructions and the manufactured home construction and safety standard,
Title 24 CFR, Part 3280 or Standard for Installation in Mobile Homes, CAN /
CSA Z240 MH.
This appliance is only for use with the type(s) of gas indicated on the rating
plate. A conversion kit is supplied with the appliance.
Warning: If the information in these instructions is not followed
exactly, a fire or explosion may result causing property damage,
personal injury or loss of life.
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
What To Do If You Smell Gas:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or
the gas supplier.
Gas Conver-
sion Instruc-
tions
For Mobile /Manufac-
tured Home approved
models:
DXFS
DFSP
DXFS-MH
DFSP-MH
Check local codes and
read all instructions
prior to installation.
Leave this manual with
the owner.
Advertisement
Related Manuals for Montigo DXFS
Summary of Contents for Montigo DXFS
-
Page 1: Prior To Installation
Gas Conver- sion Instruc- tions For Mobile /Manufac- tured Home approved models: DXFS DFSP DXFS-MH DFSP-MH This appliance may be installed as an OEM installation in a manufactured (mobile) home and must be installed in accordance with the manufacturer's... -
Page 2: Table Of Contents
This gas conversion kit contains the necessary components for field General Information ..............2 conversion of an approved Montigo fireplace from Natural Gas (NG) Parts list ..................2 to Liquid Propane (LP). This kit is approved for use with the top and... -
Page 3: Conversion
Igniter Front Burner: Pilot Hood On the DXFS and DFSP models, remove the clip that holds the Thermocouple left end of the burner tube on the burner bracket, remove the two screws securing the flame shaper, then lift the burner out of the bracket. -
Page 4: Main Gas Control Regulator
Gas Conversion Kit for DXFS/DFSP-MH models Gas Conversion Instructions Checking the Gas Pressure To check the Inlet and Manifold gas pressures, a Water Column Pres- Main Gas Control Regulator Screw: sure Gauge with 5/16" dia. tubing can be used. Make sure the gas 11. -
Page 5: Operation
Gas Conversion Kit for DXFS/DFSP-MH models Operating Instructions For Your Safety - READ BEFORE LIGHTING: WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. - Page 6 XG0667 Rev. 00 - 07/02 Montigo Del Ray Corp. Canadian Heating Products Inc. Ferndale, WA 98248 Surrey, BC V3W 2V6...