Presets (User Defined Discretes); Programming A Preset (A User Defined Ir Discrete Code); Unprogramming A Preset - Zektor HDS4x2 User Manual

Home theater solutions component video / audio matrix switch

Hide thumbs

Table Of Contents

Table of Contents

Programming a preset (a user defined IR discrete code)

The HDS4x2 allows you to setup a preset mapping of inputs to output zones and recall it with a single IR but-

ton press. Installations can be made more reliable, and IR programming for universal remotes becomes very

simple. A single IR button press can turn on the HDS4x2, and remap either or both zones to your predefined

inputs.

The HDS4x2 has 8 general use preset buttons, though any of the discrete mapping buttons can be redefined,

allowing for up to 24 defined presets.

Defining a preset on the HDS4x2 is similar to setting a station on a car radio:

Setup the HDS4x2 to the mapping you wish to save as a preset.

Use the Zone select buttons to select the zone or zones you want saved as part of the preset. Only the

zones that are flashing will be saved as part of the preset. For instance if Zone 1 is flashing, and Zone 2

is not, then only Zone 1 will be affected by the preset, Zone 2 will be left unchanged when pressing the

preset.

Once you have selected the zones to be saved as part of the preset, press the

you have selected (the ones that were flashing) will display 'v's, those that were not selected will display

'o's. If only dashes '-' are displayed, then no zones were flashing when you pressed the

this is the case, you can press the

Once the display is showing 'v's and 'o's, press one of the user defined buttons

will flash quickly 3 times and the preset will be programmed.

Now when the newly programmed button is pressed, the HDS4x2 will power on (if it is not already on), and

remap the zone(s) you selected to the inputs you specified. Similar to a preset on a car radio.

NOTE: The buttons

through

may also be used as presets, allowing for 24 user defined presets.

►

Unprogramming a preset

The buttons

Any preset can be unprogrammed. To unprogram a preset:

Press the

button, each zone will display a '-'.

SET

Press the

button, each zone will display a 'o'.

OFF

Press one of the user defined buttons

unprogrammed.

button again to cancel, and start over.

SET

through

are available as general use presets, however any of the buttons

are initially unprogrammed. An unprogrammed preset is ignored when pressed.