Table of Contents
Advertisement
Disabling front panel buttons
Enter / Exit
Enter / Exit
1
1
setup mode
setup mode
To enable or disable the front panel buttons:
1.
"Enter the setup mode", by pressing and holding the power toggle button
by pressing
SET
2.
Once the front panel is flashing, press the '2' button
3.
Use the Zone buttons
4.
Use the Breakaway button
5.
Press the Power Toggle button
onto the next section entitled: "Disabling individual front panel buttons".
NOTE: Even with the front panel buttons disabled, you will still be able to enter the setup mode by holding
the Power Toggle button. This allows you to re-enable the front panel buttons even though the buttons them-
selves are disabled.
Disabling individual front panel buttons
Select "Button enable / disable" Mode
Select "Button enable / disable" Mode
To enable / disable individual front panel buttons, start by disabling all the front panel buttons, by performing
'1' through '4' of the above steps. Then proceed:
1.
After the front panel is disabled, you can now re-enable individual buttons by selecting the "Button en-
able / disable" mode, by pressing the '3' button
the new mode selection.
2.
Use the Zone buttons
3.
Use the Breakaway button to enable or disable the selected button. Turn on the BLUE LED to enable a
button, or turn on the RED LED to disable a button.
4.
Press the Power Toggle button
The buttons are numbered from left to right, 1-8.
01 = Power Toggle, 02-05 = Input Select Buttons, 06 = Breakaway, 07-08 = Zone Select Buttons.
12
1
2
2
2
Select "Control settings"
Select "Control settings"
and then
on the remote.
4
, to scroll to the 01 setting.
3
, to turn on the RED LED.
1
, exit the setup mode and return to normal operations, or continue
1
2
7
to select the number of the button you want to enable or disable.
1
, to exit the setup mode and return to normal operations.
Advanced Control Features
3
4
Toggle setting on/off
Toggle setting on/off
2
, or
on the remote.
2
3
4
Enable / Disable
Enable / Disable
5
5
selected button
selected button
5
. The decimal point on Zone 2 will light up to indicate
HDS4x2 User Guide, Rev 1.1, 08-31-07
HDS4x2
B/A
3
3
4
4
Select setting
Select setting
1
until the display flashes, or
HDS4x2
B/A
Select button
Select button
6
6
7
7
number
number
Advertisement
Table of Contents
