Table of Contents
Advertisement
Disabling the IR remote buttons
Enter / Exit
Enter / Exit
1
1
setup mode
setup mode
To enable or disable the IR remote control buttons:
1.
"Enter the setup mode", by pressing and holding the power toggle button
by pressing
SET
2.
Once the front panel is flashing, press the '2' button
3.
Use the Zone buttons
4.
Use the Breakaway button
5.
Press the Power Toggle button
onto the next section entitled: "Disabling individual IR remote buttons".
NOTE: Only the IR remote control buttons are enabled or disabled. This setting has no effect on IR codes
sent through the IR Jack.
Disabling individual IR remote buttons
To enable / disable individual front panel buttons, start by disabling all the front panel buttons, by performing
'1' through '4' of the above steps.
1.
After the front panel is disabled, you can now re-enable individual buttons by selecting the "IR button
enable / disable" mode, by pressing the '4' button
indicate the new mode selection.
2.
Use the Zone buttons
3.
Use the Breakaway button
enable a button, or turn on the RED LED to disable a button.
4.
Press the Power Toggle button
The IR buttons are numbered from left to right, top to bottom, as shown in the section entitled: "IR remote but-
ton mapping", on page 15.
HDS4x2 User Guide, Rev 1.1, 08-31-07
1
2
2
2
Select "Control settings"
Select "Control settings"
and then
on the remote.
4
, to scroll to the 02 setting.
3
, to turn on the RED LED.
1
, exit the setup mode and return to normal operations, or continue
1
2
Select "IR button enable / disable" Mode
Select "IR button enable / disable" Mode
7
to select the number of the IR button you want to enable or disable.
6
to enable or disable the selected IR button. Turn on the BLUE LED to
1
, exit the setup mode and return to normal operations.
Advanced Control Features
3
4
Toggle setting on/off
Toggle setting on/off
2
, or
on the remote.
2
3
4
Enable / Disable
Enable / Disable
5
5
selected IR button
selected IR button
5
. The decimal points on Zones 1 & 2 will light up to
HDS4x2
B/A
3
3
4
4
Select setting
Select setting
1
until the display flashes, or
HDS4x2
B/A
Select IR
Select IR
6
6
7
7
button number
button number
13
Advertisement
Table of Contents
