Table of Contents
Advertisement
Control settings
Enter / Exit
Enter / Exit
1
1
setup mode
setup mode
To enable or disable any of the control settings: "Enter the setup mode", by pressing and holding the power
1
toggle button
until the display flashes, or by pressing
Once the front panel is flashing, press the '2' button
The HDS4x2 is now in the "Control settings" mode. This mode allows different settings of the HDS4x2 to be
enabled or disabled.
Each setting is numbered, and selected by using the Zone buttons to scroll through the setting numbers
Once a setting is selected, it can be enabled / disabled by pressing the Breakaway button
A setting is enable by turning on the BLUE LED, it's disabled by turning on the RED LED.
The settings, by number, are:
01 Enable all front panel buttons. When this setting is enabled, all front panel buttons are enabled. When
this setting is disabled, each button can be individually enabled or disabled. For more information in
this setting see the section entitled: "Disabling front panel buttons", on page 12.
02 Enable all IR remote buttons. When this setting is enabled, all IR remote buttons are active. When
disabled, each IR button can be individually enabled / disabled. For more information in this setting
see the section entitled: "Disabling the remote IR buttons", on page 13.
03 Enable / Disable front panel IR sensor hardware. When disabled, no IR can be received through the
front panel IR sensor, the IR jack is not affected.
04 Enable / Disable the rear panel IR jack. When disabled, no IR codes can be received through the rear
panel IR Jack, the front panel IR sensor is not affected. Enabling this option requires setting 06 to be
disabled.
05 Enable / Disable "Auto on". When enabled, any front panel button press will turn on the HDS4x2.
When disabled, only pressing the Power Toggle button (or the
will turn on the HDS4x2. This option does not affect the IR buttons
tons are enabled, they will always turn on the HDS4x2.
06 Enable / Disable the "12V on/off control" option. When enabled, and 12V is applied to the IR Jack,
the HDS4x2 will power on, when the 12V is removed, the HDS4x2 will power off. Enabling this setting
requires setting 04 to be disabled. For more information in this setting see the section entitled: "12V
on / off control", on page 25.
07 If set, then video will be muted as well as audio when a mute discrete code is received by the HD-
S4x2. If reset, then only the audio will be muted when a discrete code, to mute a zone, is received by
the HDS4x2.
HDS4x2 User Guide, Rev 1.1, 08-31-07
1
2
3
2
2
Select "Control settings"
Select "Control settings"
Advanced Control Features
4
Toggle setting on/off
Toggle setting on/off
and then
on the remote.
SET
2
, or
on the remote.
2
and
1
2
►
HDS4x2
B/A
3
3
4
4
Select setting
Select setting
3
.
buttons on the remote),
ON
-
or
-
, if these but-
A
H
8
2
►
4
.
11
Advertisement
Table of Contents
