Table of Contents
Advertisement
Front panel display intensity and modes
The HDS4x2 has three intensity levels that can be adjusted, they are:
BRIGHT - This is the level of brightness seen when a front panel button is pressed.
DIM
- This is the intensity level reached after the display auto-dims.
OFF
- This is the level of the standby LED when the HDS4x2 is in standby mode.
Enter / Exit
Enter / Exit
1
1
setup mode
setup mode
To change the LEDs intensity, or operating modes: "Enter the setup mode" by pressing and holding the power
1
toggle button
until the display flashes, or by pressing
Once the front panel is flashing, press the '1' button
the intensity of the BRIGHT level.
To toggle between the BRIGHT, DIM and OFF adjustments use the breakaway button
the remote. The RED and BLUE LEDs indicate which adjustment level is being displayed:
BLUE
- Adjust BRIGHT level.
RED
- Adjust DIM level.
BLUE & RED - Adjust OFF level.
Use the zone select buttons
The HDS4x2 can be setup to operate in four different display modes: OFF, LOW, HIGH, AUTODIM.
5
5
Select "Intensities"
Select "Intensities"
Exit setup
Exit setup
To change modes, press the '2' button
ing mode of the HDS4x2. Use the zone select buttons
different operating modes, the current operating mode is displayed using the input selection LEDs.
The modes are:
OF
- OFF
LO
- LOW
H1
- HIGH
AU
- AUTODIM
You can change back to the intensity setting by pressing the '1' button
When all adjustments have been made, press the Power Toggle button
normal operations.
10
1
2
Select front panel
Select front panel
2
2
control mode
control mode
4
, or
-
on the remote, to raise and lower the intensity of the display.
O1
O2
1
2
6
6
7
7
Select "Modes"
Select "Modes"
7
, or
LEDs are always off.
LEDs are always at the DIM intensity.
LEDs are always at the BRIGHT intensity.
LEDs dim from BRIGHT to DIM when not in use.
Advanced Control Features
3
4
Toggle intensity settings
Toggle intensity settings
and then
SET
2
, or
on the remote. The display will now indicate
1
3
4
on the remote. The display will indicate the current operat-
2
8
, or
-
on the remote, to toggle between the
O1
O2
6
HDS4x2 User Guide, Rev 1.1, 08-31-07
B/A
3
3
4
4
Adjust intensities
Adjust intensities
on the remote.
3
, or
,
A/V
B/A
8
8
Choose mode
Choose mode
, or
on the remote.
1
5
, or
on the remote, to return to
HDS4x2
,
on
AUD
VID
HDS4x2
Advertisement
Table of Contents
