Initial Power On Settings; Changing The Initial Power On Settings - Zektor HDS4x2 User Manual

Changing the initial power on settings

As long as power is applied to the HDS4x2 it will remember its current state when toggled from on to standby
mode, and back to on. However if power is lost (the HDS4x2 is unplugged, or switched off using a power strip,
or a power failure, etc.), the HDS4x2 will power up using its predefined settings.
By default, when power is first applied to the HDS4x2, it powers up in the standby mode, with Zone 1 select-
ed, and both Zones 1 and 2 mapped to Input 1.
These defaults can be easily changed.
Press and hold the Press and hold the
1 1
power toggle button . . . power toggle button . . .
Start by setting the HDS4x2 to the new power on state desired.
For example, the above illustration shows the HDS4x2 turned on, with Zone 1 selected and mapped to Input
1, and Zone 2 unselected and mapped to Input 4.
Once you've set the HDS4x2 into the power on state of choice, you can save these settings as the new power
on defaults.
To set new power on defaults using the front panel:
1. Press and hold the Power Toggle button
2. While continuing to hold the Power Toggle button, also press and hold the Breakaway button
3. Continue to hold both these buttons until the display flashes quickly 3 times.
To set new power on defaults using the remote control:
1. On the remote, press the
2. The display will flash quickly 3 times.
After a power failure, the HDS4x2 will now power up using the new settings.
8
1 2 3
press and hold the breakaway button press and hold the breakaway button
1
.
button followed by the
SET

Initial Power On Settings

4
. . .while holding the power toggle, . . .while holding the power toggle,
button.
ON
HDS4x2 User Guide, Rev 1.1, 08-31-07
  HDS4x2
B/A
2 2
2
.