Table of Contents
Advertisement
Setup mode overview (read this first)
1
1
Press and hold
Press and hold
All control functions of the HDS4x2 are accessed through the setup mode, and all the following instruction will
ask you to "Enter the setup mode" as their first step. To enter the setup mode:
1.
Press and hold the power toggle button
the setup mode, using the remote, by pressing
2.
The display will be flashing wildly
Once the display is flashing, you are in the setup mode.
To abort the setup mode (if you've changed your mind), press the power toggle button
mote control. The HDS4x2 will return to normal operation.
NOTE: At this point you should refer to the section in the manual that describes the control mode of interest.
The following is simply a short description of each of the available control modes, but not how to use them.
Control modes are entered by pressing one of the input select buttons
the modes are defined in detail in the following sections, but briefly they are (listed by selection number):
1.
Front panel dimming and intensity settings.
2.
Control settings. This includes front panel and IR enabling and disabling, IR Jack control, and auto
power on when a button is pressed.
3.
Reserved.
4.
IR Learning. This mode allows the HDS4x2 to learn new IR codes, allowing it to use a remote different
from the one supplied. This is useful when using more than one HDS4x2 in the same room. This mode
cannot be entered using the remote control, you must press the '4' button on the HDS4x2's front panel.
NOTE: All control changes made to the HDS4x2, will be saved in non-volatile memory, and will be retained
through a power failure.
HDS4x2 User Guide, Rev 1.1, 08-31-07
1
2
3
2
2
Control mode selection
Control mode selection
1
until the display starts doing the "wave", or you can enter
3
.
Advanced Control Features
Display flashes
Display flashes
4
and then
.
SET
2
, or
3
3
HDS4x2
B/A
1
, or
on the re-
-
on the remote control,
1
3
Advertisement
Table of Contents
