Belkin ADSL2+ User Manual page 29

Manually Configuring your Modem/Router Manually Configuring your Modem/Router
LAN Settings
(1)
(2)
(3)
(4)
(6)
(5)
1. IP Address
The "IP address" is the internal IP address of the Modem/Router.
The default IP address is "192.168.2.1". To access the setup
interface, type this IP address into the address bar of your
browser. This address can be changed if needed. To change
the IP address, type in the new IP address and click "Apply
Changes". The IP address you choose should be a non-routable
IP. Examples of a non-routable IP are:
192.168.x.x (where x is anything between 0 and 255)
10.x.x.x (where x is anything between 0 and 255)
2. Subnet Mask
There is no need to change the subnet mask as the Modem/Router
will automatically adjust the length based on the IP address type.
3. DHCP Server
The DHCP server function makes setting up a network very easy
by assigning IP addresses to each computer on the network
automatically. The default setting is "On". The DHCP server can
be turned OFF if necessary, however, in order to do so you must
manually set a static IP address for each computer on your network.
To turn off the DHCP server, select "Off" and click "Apply Changes".
4. IP Pool
The IP Pool is the range of IP addresses set aside for dynamic
assignment to the computers on your network. The default is
26 26