Specifying The Center Staple And Fold Setting; Hole Punching - Oce cm5520 User Manual

5

Specifying the center staple and fold setting

You can specify to center staple and fold a printed document. By specifying
the center staple and fold setting, printed documents can be folded in half
and stapled.
Reminder
The center staple and fold function is available only when optional finisher
9834 is installed.
1
Click the Finish tab.
2
Select the "Center Staple and Fold" check box.
Note
The center staple and fold function cannot be specified when the staple,
punch, or fold function is specified.

Hole punching

Holes can be punched into the printed document.
Reminder
The hole punch function is available only when the punch kit is installed
on the optional finisher.
1
Click the Finish tab.
2
Select the "Punch" check box.
3
From the drop-down list, specify the number of punched holes.
Note
The hole-punch position changes according to the binding position spec-
ified from "Binding Position".
5-22
Setting up the PCL driver (Windows)
cm5520