Oce im4530 Printing Manual page 303

- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
For im4530 Sereis, "Tray 1" and "Tray 2" can be selected when the Hanging Finisher,
Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
When the Finisher (Type B) is installed in the im4530 Series and stapling is enabled,
select "Tray 2".
For im2830 Sereis, "Tray 1" and "Tray 2" can be selected when the Hanging Finisher is
installed, and "Tray 1" can be selected when the Saddle Stitch Finisher is installed.
When the optional Job Separator is installed, you can select "Job Separator Upper" and
"Job Separator Lower" instead of "Inner Tray".
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
This option cannot be selected if a hole punch unit is not installed.
Printing from Application on Mac OS 8.6 to 9.x 301