Table of Contents
Advertisement
ITEM
Print
X
Setup
Dimension
(cont.)
PS Setup
Y
Dimension
Network
Protocol
Parallel
Protocol
USB
Protocol
PCL
Font
Setup
Source
Font
Number
39
SETTINGS
64 mm
~
210 mm
~
216 mm
127 mm
~
297 mm
~
1220 mm
ASCII/RAW
ASCII/RAW
ASCII/RAW
Resident
I0 ~ I90
– VarioLink 3550cp Series User's Guide
EXPLANATION
Specifies paper width of
Custom paper as a default
value.
Sets a paper size at right angles
to the paper run direction.
Specifies paper length of
Custom paper as a default
value.
Sets a paper size in the same
direction as the paper run
direction.
Specifies PS communication
protocol mode of data from NIC
port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
Specifies PS communication
protocol mode of data from
Centronics port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
Specifies PS communication
protocol mode of data from USB
port.
(In RAW mode, Ctrl-T is
invalid). PS models only.
Specifies the location of PCL
default font.
Sets the PCL font number.
The valid range of this variable
changes depending on the
FONT SOURCE setting at the
time. If the default font is set
for FONT SOURCE, the number
starts at 0. If it is not, the
number starts at 1. The
maximum value is equal to the
number of fonts installed in
FONT SOURCE.
Advertisement
Table of Contents
