Table of Contents
Advertisement
Programming (Cont.)
DMX Control With ID
Addressing
Static Color
Auto Programs
Edit Customs
Master/Slave
February 16, 2010
In this mode, the fixtures with the same DMX starting address will respond to the DMX
controller based on the fixture's individual ID address setting. If the user selects ID
address "0", all the fixtures with the same DMX address will respond in unison.
Otherwise, each fixture will follow the control for its particular ID address.
1) Repeat steps 1, 2 and 3 from DMX Control Without ID Addressing.
2) Activate ID Addressing in each fixture:
a) Go to SETTINGS > ID ON/OFF.
b) Select ON.
3) Select an ID address for each fixture:
a) Go to ID Address.
b) Select an ID address (1~66)
The Static Color mode allows for permanent RGBW color mixing without a DMX
controller.
1) Go to STATIC.
2) Select the desired color (RED, GREEN, BLUE, or WHITE).
3) Select the desired color value (0~255).
4) Repeat for the other colors.
5) Select STROBE.
6) Select the desired frequency (0~20).
Auto programs allow for dynamic RGBW color mixing without a DMX controller. This
fixture has 10 preset and 10 customizable automatic programs.
1) Go to AUTO.
2) Select the desired auto program (AUTO 01~10 or CUSTOM 01~10).
You cannot edit the auto programs (AUTO 01~10). However you can edit custom
programs CUSTOM 01~10 (see Edit Customs).
This setting allows the programming of up to 99 scenes for each of the 10 customizable
programs, including colors and effects.
1) Go to EDIT.
2) Select the desired auto program (CUSTOM 01~10).
3) Select the desired scene (SCENE 01~99).
4) Select the desired color or effect (RED, GREEN, BLUE, WHITE, STROBE, TIME or
FADE).
5) Adjust the color or effect (000~255 for colors and timers, or 00~20 for Strobe).
6) Repeat for the other colors or effects.
7) Repeat for the other scenes.
The Master/Slave mode allows a group of COLORado™ 3p Tour fixtures (the slaves) to
execute simultaneously the same program, whether auto or custom, that another
COLORado™ 3p Tour fixture (the master) is executing, without a DMX controller.
1) Set the Master unit:
a) Set the running mode to DMX as explained in "DMX Control Without ID
Addressing".
b) Select an Auto program as explained in "Auto Programs".
2) Set the slave units:
a) Go to RUN.
b) Select SLAVE.
a) The fixture that runs an auto program automatically becomes the Master.
b) Do not connect a DMX controller to the master or slave fixtures.
-11-
Operation
COLORado™ 3p Tour User Manual Rev. 02c
Advertisement
Table of Contents
