Fujitsu PRIMEQUEST 2000 Series Design Manual page 34

2.2.2 Memory (1/7)
Supported memory types are 8GB, 16GB, 32GB, and 64GB DDR3 DIMM.
Install a set of two DIMMs.
n
• Install a set of four DIMMs to use the Memory Mirror function
(Refer to "2.2.2 Memory
• Install a set of six memory modules to use the Memory Spare function
(Refer to "2.2.2 Memory
• When either Dynamic Reconfiguration is used or one PPAR block is configured with eight CPUs
and the Segment Mode is set as the PCI Address mode.
(Refer to "2.2.2 Memory
For one CPU, six sets of memory modules can be installed
n
in the memory slots on the SB and another six sets of
memory modules can be installed on an optional extended
memory board.
Installed memory operates only when the relevant CPU is operating.
n
Installation Group
n
• Install memory modules on a set basis in two memory slots with
memory slot numbers whose third digits have a difference of 3.
Installation Group (1 CPU and Normal Mode)
Installation group
1
2
3
4
5
6
:
24
PRIMEQUEST 2000 Series Design Guide
(4/7)".)
(4/7)".)
(5/7)".)
Memory slot numbers
0A0, 0A3
0A1, 0A4
0A2, 0A5
0B0, 0B3
0B1, 0B4
0B2, 0B5
:
1D2, 1D5
33
Memory Slot Arrangement
: Memory slots on an extended memory board
Copyright 2014 FUJITSU LIMITED