Dial-In Setup Of Remote Phone; Deactivating Dial-Up Remote Phone - Linksys SPA-941 User Manual

Dial-in Setup of Remote Phone

Deactivating Dial-up Remote Phone

Linksys SPA-941 Telephone User Guide
620-05600390
W A R N I N G
If you dial an emergency number (such as 911) from the remote phone
while it is in remote mode (the phone will be playing on-hold music),
an announcement tells you that number is not allowed from Remote
Phone and advises you to hang up the phone and try again. Until you
hang up the phone and disconnect from the Remote Phone feature,
you will receive the announcement.
There are two ways to enable the Remote Phone feature:
•
by dialing a special DID number, or
•
through the Web Portal under Options > Remote
To set up a remote phone by dialing in, you must call using the remote phone where
your VoIP phone calls will be forwarded.
1. From the remote phone (example, your cell phone or a hotel phone), dial the
Remote Phone access DID number.
Your service provider should have provided this number to you.
2. Enter the phone number of your VoIP phone followed by the pound sign (#).
EXAMPLE: 9723353421# or 9723352100*2001# for Non-DID numbers.
3. Enter the password for your VoIP phone followed by #.
4. DO NOT hang up the destination phone. Leave it off-hook.
5. If a call comes in, press star (*) to answer the call.
6. Disconnect from a call by pressing "###", which will leave the Remote Phone
active (you will hear hold music playing).
NOTE: Be aware that if you are using a cell phone, the phone is still in an active call.
If you hang up the remote phone, it will disconnect the call and deactivate the
Remote Phone mode.
Dial-in Setup of Remote Phone
System Telephone Features 53