Table of Contents
Advertisement
ELECTRICAL FEEDER CABLE
CONNECTION
To connect the supply cable:
- Remove the screws securing the
cover "A" on the rear of the cooker
(fig. 9.1).
- Feed the supply cable through the
cable clamp "D". The supply cable
must be of a suitable size for the cur-
rent requirements of the appliance;
see the section "Feeder cable section"
(fig. 9.1).
- Connect the wires to the terminal
block "B" as shown in the diagram in
figure 9.2; or connect the phase wires
to the terminal block "B" and the earth
wire to the terminal PE (fig. 9.1) as
shown in figure 9.2.
- Take up any slack in the cable and
secure with the cable clamp "D".
- Replace the cover "A".
B
A
Fig. 9.1
PE
D
FEEDER CABLE SECTION TYPE
HO5RR-F
230 V
3 x 0,75 mm
230 V
L
1
(L
REMPLACEMENT OF ELECTRICAL
COMPONENTS SITUATED UNDER
THE COOKTOP
Before effecting any intervention on
the electrical parts of the appliance,
the connection to the network must
be interrupted.
Switches igniter and electrodes can be
replaced after lifting the cooktop, follow-
ing the instructions shown in the chapter
"REPLACEMENT OF THE TOP INJEC-
TORS".
2
N
PE
)
2
Fig. 9.2
35
Advertisement
Table of Contents
