Table of Contents
Advertisement
These operations must be carefully ful-
filled as follows.
GAS CONNECTION
– Connect the cooker to the gas mains
utilizing rigid or flexible pipes.
– The connection must be executed to
the rear of appliance (left or right) (fig.
8.1); the pipe do not cross the cooker.
– The unused end inlet pipe of the cook-
er (left or right) must be closed with the
plug interposing the gasket.
Gas connection for:
II
Cat:
2H3+
The fitting (fig. 8.2) is made up of:
– 1 adapter "C" for G20
– 1 adapter "B" for G30/G31
– gasket "D"
D
B
Fig. 8.2
26
C
Natural gas G20
– Fit up the holder "C" interposing gasket
"D".
– Connect the cooker to the gas net by a
suitable rubber tube (inside diameter
15 mm).
Make sure the tube is snugly fit at both
ends and use a standard tube clamp (not
supplied) to fasten it.
L.P.G. G30 / G31
– Fit up the holder "B" interposing gasket
"D".
– Connect the cooker to the cylinder
pressure regulator by a suitable rubber
tube (inside diameter 6 mm).
Make sure the tube is snugly fit at both
ends and use a standard tube clamp (not
supplied) to fasten it.
The rubber tube:
- must be as short as possible, with-
out contractions or kinks;
- must be easy to inspect along its
entire length to check its wear;
- must never be at any point in its
length in contact with the "hot" parts
of the cooker.
Fig. 8.3
Advertisement
Table of Contents
