D-Link DCS-1000 Manual page 17

The default setting for the LED control is at Normal.
configured the LED control the correct illumination will set in after 1 minute.
Note:
This function is built-in to the LED indicators to add extra capabilities. The
three options allow the Administrator to configure and camouflage the
illumination for the LED indicator to falsify the monitoring status. In Normal
Mode the LED indicator functions as normally. Under Off Mode the LED
indicators are both off however, it is still monitoring the activity. In Dummy
Mode the LED indicators operate in monitoring condition but monitoring
activity is off or on.
Loading ActiveX From:
This field is used to specify the location of Xplug Control (ActiveX) plug-in
program. Enter the information as required in .ocx format, for example:
http://www.<your company>.com/xplug.ocx where <your company> must be
replaced with your company's DNS server.
Open Second Port:
The Web Server field allows settings to open a second port for DCS-1000.
This will permit users IP Sharing Gateways to support multiple DCS-1000s.
By default Port 80 is always opened for DCS-1000 Web Server access. Select
"Yes" and input the second port value.
For example: If you have 5 Internet Cameras to be installed, each with an IP
address from
192.168.0.101
192.168.0.102
192.168.0.103
192.168.0.104
192.168.0.105
You can open the second port for each Internet Camera from port 81 to Port
85 as illustrated below:
DCS-1000 1 – IP 192.168.0.101, second web port 81
Power - Steady On of the LED indicator.
LAN -
Steady On of the LED indicator with random flashing.
16
When you have