Table of Contents
Advertisement
Part Names and Functions
Remote Control Battery Installation
Open the battery
1
compartment lid.
Press the lid
downward and slide it.
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Remote Control Operating Range
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4'(5 m)
and 60 degrees in front of the projector.
Remote Control Code
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote
control codes prevents interference from other remote controls when several projectors or video equipment
next to each other are operated at the same time. Change the remote control code for the projector first before
changing that for the remote control. See "Remote control" in the Setting Menu on page 55.
1
While pressing the MENU button, press the IMAGE
button number of times corresponding to the remote
control code. See the list below.
To initialize the remote control code, slide the RESET/
ON/ALL-OFF switch to RESET, and then to ON. The
initial code is set to Code 1.
Remote Control Code
Code 1
Code
Code
Code 4
Code 5
Code 6
Code 7
Code 8
1
Install new batteries
into the compartment.
Number of Times
Pressing IMAGE
Button
1
4
5
6
7
8
Two AAA size batteries
For correct polarity
(+ and –), be sure
battery terminals are
in contact with pins in
compartment.
30°
30°
While pressing the MENU
button, press the IMAGE
button number of times
corresponding to the remote
control code.
Replace the
compartment lid.
16.4'
(5 m)
Remote control
MENU button
IMAGE button
RESET/ON/ALL-
OFF switch
Advertisement
Table of Contents
