Table of Contents
Advertisement
Handset Operation
Transferring Calls
Transfer Calls to the Cordless
You can transfer an active call from the DKT to the cordless or vice versa by using
. If the cordless is idle, the transfer takes place immediately.
1. While in conversation, press
LED flashes.
2. Press
steady. The DKT LEDs go out and displays "CORDLESS
MODE.".
3. Press
Transfer Calls to the DKT
1. Press
2. Pick up the DKT telephone and press the flashing Line LED.
Using Camp-on
1. Press
conference rate.
2. Enter the destination [DN], Hunt Group number, or ACD group [DN]. You hear a
single tone.
If the call was made with Tone Signaling instead of Voice First Signaling, you
Note
hear ringing tone.
3. When the [DN] answers, announce the call. If the called station does not answer,
you receive a recall ring (when your station or [DN] is idle). The ring is set by
system programming.
4. Press
the transferred call.
...or
answered or busy tone is received.
The Line LED changes to steady red when the called station connects with the
transferred call. After you hang up, the Line LED begins to flash at the on-hold rate
or if you transferred the call from a [DN], the [DN] LED goes out. The CO Line or
[DN] camps onto the called station and the called station receives a warning tone.
24
on the Cordless handset The Cordless LED lights
on the Cordless handset (shown right).
on the cordless handset.
. You hear dial tone and the Line or [DN] LED flashes at the
. The Line LED changes to steady when the called station connects with
, [DN] +
to reconnect to the transferred line before the call is
on the DKT. The Line
Strata DKT2104-CT Cordless Digital Telephone 01/02
4505
Advertisement
Table of Contents
