Fitting The Hob To The Worktop - Zanussi ZGF 789 Instruction Booklet

Fitting the hob to the worktop

Carry out the building in of the hob as follows:
• put the seals supplied with the hob, on
the edges of the cut out: place them at
8 mm from the front and rear edge and
at 50 mm from the side edges, as
shown in figure 6, taking care that the
seals meet without overlapping;
• place the hob in the cut out, taking care
that it is centred;
• fix the hob with the relevant fixing clamps
and screws, as shown in figure 7. When
the screws have been tightened, the
excess seal can be removed.
The edge of the hob forms a double seal which
prevents the ingress of liquids.
FO 0199
Fig. 6
a
Seal
Fig. 7
9