Fitting The Hob To The Worktop - Zanussi PN 64 Instruction Booklet

Building over a kitchen
unit with oven
If the hob is built into a kitchen unit with an
oven underneath, the recess must have the
dimensions shown in diagrams 2 and 3, and
should also incorporate suitable oven
crosspiece supports to ensure an efficient
cooling air circulation.
Diagrams 4 and 5 give two building-in
examples.
The electric connection of the hob and
the oven should be carried out
separately, for electrical safety reasons
to permit easy extraction of the oven
from the front part of the kitchen unit.

Fitting the hob to the worktop

Carry out the building in of the hob as follows:
• put the seals supplied with the hob, on the
edges of the cut out: place them along the
side edges and at 8 mm from the front and
rear edge, as shown in the diagram, taking
care that the seals meet without overlapping;
• place the hob in the cut out, taking care that it
is centred;
• fix the hob with the relevant fixing clamps and
screws, as shown in the diagram. When the
screws have been tightened, the excess seal
can be removed.
The edge of the hob forms a double seal which prevents
the ingress of liquids.
480
380
140
FO 2043
FO 2041
FO 0199
2
550 min.
FO 0198
4
FO 2042
3
5
a
Seal
9