Fitting The Hob Into The Worktop - Zanussi ZGF 7521 Instruction Booklet

Fitting the Hob into the Worktop

Carry out the building in of the hob as
follows:
• put the seals supplied with the
hob, on the edges of the cut out:
place them exactly on the front
and rear edge and at 50 mm. from
the side edges, as shown in the
diagram, taking care that the
seals meet without overlapping;
• place the hob in the cut out,
taking care that it is centred;
• fix the hob with the relevant fixing
clamps and screws, as shown in
the diagram. When the screws
have been tightened, the excess
seal can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
Seal
19