Related Manuals for Zanussi ZGF 753
Summary of Contents for Zanussi ZGF 753
- Page 1 GAS HOB √A«OBAfl BAPO◊HAfl œOBEPXHOCT‹ ZGF 753 ZGF 783 INSTRUCTION BOOKLET P” OBOƒCTBO œO › CœÀ”ATA÷»»...
-
Page 3: For Your Safety
Repairs carried out by installing a cooker hood with discharge tube. unexperienced persons may cause injury or serious malfunctioning. Refer to your local Zanussi Service • In case of intensive or long time use of the Centre. Always insist on genuine Zanussi spare appliance, make the ventilation more efficient, parts. -
Page 4: Table Of Contents
Contents Instruction for the User ....Pag. Electrical Connection ..... Pag. Adaptation to different Cleaning and Maintenance .... Pag. types of gas ........Pag. Technical Data ........ Pag. Building In ........Pag. Instruction for the Installer .... Pag. Guarantee ........Pag. Instruction for the User HOB BURNERS CONTROL KNOBS USING THE HOB CORRECTLY... -
Page 5: Cleaning And Maintenance
THE HOB LID Always clean the lid from cooking residues before In order to make the appliance match with the kitchen opening it or taking it off. design, a lid (not provided) can be fitted on the hob. WARNING! The crystal lid can splinter when The lid is meant to avoid dust to settle on the overheated. -
Page 6: Technical Data
Technical Data Gas Burners Rating Double crown Burner 3,5 kW Gas connection G 1/2" Rapid Burner (big) 3 kW (G20) - 2,8 kW (G30-31) Electric Supply 230 V 50 Hz Auxiliary Burner (small) 1 kW Semirapid Burner (medium) 2 kW HOB RECESS DIMENSIONS Class 3 Appliance... -
Page 7: Electrical Connection
Electrical Connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label);... -
Page 8: Adaptation To Different Types Of Gas
Adaptation to different types of gas INJECTORS REPLACEMENT • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 7), and replace them with the ones required for the type of gas in use (see table 2). •... -
Page 9: Building In
Building In Fig. 9 A = Auxiliary burner SR = Semirapid burner R = Rapid Burner UR = Double crown burner These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. - Page 10 INSTALLATION AND ASSEMBLY These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. 13. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 150 mm.
- Page 11 POSSIBILITIES FOR Fig. 17 Fig. 16 INSERTION Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig.
-
Page 12: Guarantee
DECLARATION OF GUARANTEE TERMS (BELGIUM) Our appliances are produced with the greatest of non-original accessories or spare parts are not care. However, a defect may still occur. Our consumer covered by the guarantee. services department will repair this upon request, 10.