Europe-EU Declaration of Conformity ........5 France ..................6 Symbols used in this guide............7 Important Safety Precautions............8 Overview..................10 Components ................10 Front view – wall mount version ..........12 Front view – desktop version..........12 Front view – desktop version..........13 Rear View................14 BEETLE /Fusion – Operating Manual 01750166736 G...
Page 5
Barcode reader .................21 Notes on the laser ..............21 Proximity Sensor ..............22 Appendix ...................23 Technical Data for BEETLE /Fusion 12........23 Technical data for BEETLE /Fusion 15 ........24 Technical data for BEETLE /Fusion 19 ........25 AC Power Adapter..............26 Power Cord Selection.............27 System specification...............28 I/O connection ports ...............31...
The device complies with the requirements of the EEC directive 2004/108/EC with regard to “Electromagnetic compatibility” and 2006/95/EC “Low Voltage Directive”. Tested Safety The BEETLE /Fusion has been provided with the symbol for “Tested Safety”. In addition, the device has received the UL symbol and cUL symbol.
The device complies with the requirements of the BSMI (Bureau of Standards, Metrology and Inspection, Ministry of Economic Affairs) directive CNS13438 with regard to “Electromagnetic compatibility” with the limits for a Class B product. BEETLE /Fusion – Operating Manual 01750166736 G...
Technical & Regulatory Information on Wireless Wireless Interoperability The WLAN adapter integrated in the BEETLE /Fusion is designed to be interoperable with any wireless LAN product that is based on direct sequence spread spectrum (DSSS) and to comply with the following standards: ·...
Any deviation from permissible settings and restrictions in the country of use could be an infringement of national law and may be punished as such. BEETLE /Fusion – Operating Manual 01750166736 G...
Deze apparatuur voldoet aan de noodzakelijke vereisten van EU-richtlijn betreffende radioapparatuur en telecommunicatie-eindapparatuur R&TTE 1999/5/EG. Dette udstyr opfylder de Væsentlige krav i EU's direktiv R&TTE 1999/5/EC om Radio- og teleterminaludstyr. Dette utstyret er i overensstemmelse med hovedkravene i R&TTE-direktivet (1999/5/EC) fra EU. 01750166736G BEETLE /Fusion – Operating Manual...
Indoor use: maximum power (EIRP) of 100 mW for the entire 2400- 2483.5 MHz frequency band. · Outdoor use: maximum power (EIRP) of 100 mW for the 2400-2454 MHz band and with maximum power (EIRP) of 10 mW for the 2454- 2483.5 MHz band. BEETLE /Fusion – Operating Manual 01750166736 G...
Texts following this symbol are actions to be performed in WARNING order to avoid damage or injury. This symbol identifies paragraphs which contain general NOTE notes to facilitate use of the device and help avoid operating errors. 01750166736G BEETLE /Fusion – Operating Manual...
If the liquid comes into contact with your eyes, consult a medical doctor immediately. Make sure that there is always free access to sockets used or to the electrical circuit-breakers of the house installation. BEETLE /Fusion – Operating Manual 01750166736 G...
Page 14
Only use accessories and extension components that have been approved by us. Nonobservance can result in damage to the system or violations of regulations concerning safety, radio interference and agronomical requirements. To clean the device only use cleaning agents approved by Wincor Nixdorf International GmbH. Repairs WARNING Repair work may only be carried out by authorized personnel.
Overview Overview The BEETLE /Fusion is a family of POS terminal that is configurable for wall mount or desktop application. It is designed for indoor installation. Components The configuration of the Fusion may comprise of the following components: Processor options:...
Page 16
Overview Mounting options: § wall mount version § desktop version 01750166736G BEETLE /Fusion – Operating Manual...
Overview Front view – wall mount version Camera & microphone Display Stereo speakers LED ON/OFF Barcode reader Power ON/OFF Proximity sensor Brightness adjustment BEETLE /Fusion – Operating Manual 01750166736 G...
Overview Front view – desktop version Camera & microphone Display Stereo speakers LED ON/OFF Brightness adjustment Barcode reader Power ON/OFF Proximity sensor Desktop stand 01750166736G BEETLE /Fusion – Operating Manual...
Access cover for HDD, CF & miniPCle Access cover for memory module 100mm VESA mount holes Cable Cover Back cover assembly consisting of a plastic exterior cover with an inner metal shield Front bezel BEETLE /Fusion – Operating Manual 01750166736 G...
Remove the cable cover. · Inset the IEC connector of the cable into power supply. · Plug the 24V plug into the jack on the BEETLE / FUSION (see arrow below). Put the safety plug in the socket of the building installation. ·...
Page 21
Check all connections on a fixed and correct position and turn the power back If the problem persists, turn the unit off again and pull the plug. Inform the Technical Support, Wincor Nixdorf. BEETLE /Fusion – Operating Manual 01750166736 G...
The key for this setting are at the lower right side of the display unit (see · figure below). · Press the ‘Arrow Up’ or ‘Arrow Down’ buttons to adjust the brightness until the appropriate adjustment is acceptable by the user. 01750166736G BEETLE /Fusion – Operating Manual...
IR ray. Due to its sensitivity, always make sure that the IR touch screen is dust free to obtain optimum touch performance. BEETLE /Fusion – Operating Manual 01750166736 G...
Use a soft, fine-meshed cloth to clean the surface. Dampen the cloth slightly and then clean the screen. A wrong maintenance may cause damages to the screen, which are not covered by guarantee or warranty. 01750166736G BEETLE /Fusion – Operating Manual...
Operation The digital camera with integrated digital microphone is located near the top edge of the BEETLE /Fusion. Picture or video can be taken under the control of the software application. The range of focus for the digital camera is from 60cm onward.
Hold the barcode in a landscape format underneath the barcode reader. The laser beam will start automatically. The laser beam must cover the whole width of the barcode. A successful reading of the barcode will be quit with a beep. Notes on the laser 01750166736G BEETLE /Fusion – Operating Manual...
The application can react to this message e. g. by sending out acoustic signals or by changing the content on the monitor. BEETLE /Fusion – Operating Manual 01750166736 G...
Appendix Appendix Technical Data for BEETLE /Fusion 12 Wall mount Desktop Dimensions Height 296 mm 420 mm Depth 96 mm 265 mm Width 320 mm 320 mm Weight of device 6.3 kg 9.0 kg Climatic category Operating IEC 721-3-3 class 3K3+ 5° to +40°C Transport IEC 721-3-2 class 2K2 -25°...
Appendix Technical data for BEETLE /Fusion 15 Wall mount Desktop Dimensions Height 336 mm 430 mm Depth 96 mm 265 mm Width 370 mm 370 mm Weight of device 6.8 kg 9.5 kg Climatic category Operating IEC 721-3-3 class 3K3+ 5° to +40°C Transport IEC 721-3-2 class 2K2 -25°...
Appendix Technical data for BEETLE /Fusion 19 Wall mount Desktop Dimensions Height 342 mm 434 mm Depth 96 mm 265 mm Width 476 mm 476 mm Weight of device 8.0 kg 10.7 kg Climatic category Operating IEC 721-3-3 class 3K3+ 5° to +40°C Transport IEC 721-3-2 class 2K2 -25°...
Appendix AC Power Adapter The AC power adapter used must be Wincor Nixdorf’s qualified and has to meet the following minimum requirements and industry standards: Rated Input voltage 100 - 240 Vac Input Voltage range 90 to 264Vac Input Frequency range...
Safety Regulation of the country. Countries Safety Approvals Canada Germany Japan Taiwan BSMI China For other countries not mentioned in the above list, please check with the local authority. 01750166736G BEETLE /Fusion – Operating Manual...
Appendix Total Available Power of External I/O Ports The total power available for the external IO ports depends on the choice of AC power adapter used. Below is the Wincor Nixdorf’s approved AC power adapter for BEETLE /Fusion. Wincor P/N...
Page 38
See the Approved Printer List in the following section if printer is used with the +24Vdc Powered USB port For model BEETLE /Fusion 19, the USB3 24V powered USB output and the USB4 12V powered USB output are not Limited Power Source according to IEC 60950.
Appendix Approved Printer List The following are the approved printers that are allowed to be connected to the BEETLE /Fusion’s +24Vdc Powered USB port: Model Manufacturer TH230 Wincor Nixdorf TH320 Wincor Nixdorf TH420 Wincor Nixdorf ND210 Wincor Nixdorf ND77 Wincor Nixdorf...
Page 40
Published by Wincor Nixdorf Pte Ltd 2, Kallang Sector Singapore 349277 Part No.: 01750166736 G...