Auxiliary Dc Jack (Fx10Mt / Fx10Mtr / Fx10Mtra); Brake Lever - Yamaha FX Nytro FX10X Owner's Manual

Control functions
1. Grip/thumb warmer adjustment switch
To raise the temperature
To raise the grip warmer temperature, press
the " " side of the switch. To raise the thumb
warmer temperature, press the "
the switch.
To lower the temperature
Continue to press the switch until the temper-
ature level returns to the minimum level, and
then raise the temperature to the desired lev-
el.
ESU10690
Auxiliary DC jack (FX10MT /
FX10MTR / FX10MTRA)
The auxiliary DC jack is located in the front
panel and can be used for accessories.
NOTE:
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
16
1. Auxiliary DC jack cap
2. Auxiliary DC jack
NOTE:
After using the auxiliary DC jack, be sure to
" side of
remove the accessory power plug from the
jack and close the auxiliary DC jack cap.
ECS00120
CAUTION:
Do not use accessories requiring more
G
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 67 for the specified amperage.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU10560
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.

Brake lever