Table of Contents
Advertisement
ESU10691
Auxiliary DC jack (FX10MTR)
The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1.
Start the engine.
2.
Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3.
After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS00120
NOTICE
Do not use accessories requiring more
G
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 69 for the specified amperage.)
Do not use an automotive cigarette light-
G
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
Control functions
ESU10560
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
1. Brake lever
TIP
When the brake lever is operated, the brake
light will illuminate.
ECS00060
NOTICE
Make sure that the brake lever end does
not project out over the handlebar end.
This will help prevent brake lever damage
when the snowmobile is placed on its side
for service.
The brake lever is equipped with a position
adjuster.
To adjust the brake lever position:
1.
Loosen the locknut.
2.
While lightly pushing the brake lever in di-
rection (a), finger tighten the adjusting
bolt to set the brake lever to the desired
position.
15
Hide quick links:
Advertisement
Table of Contents
