Yamaha FX Nytro FX10X Owner's Manual page 57

1. Engine oil drain bolt (oil tank)
8. Place an oil pan under the engine to col-
lect the used oil.
9. Remove the engine oil drain bolt to drain
the oil from the crankcase.
1. Engine oil drain bolt (crankcase)
2. " " mark
NOTE:
A " " mark is stamped on the crankcase
G
near the engine oil drain bolt.
Dispose of used oil according to local regu-
G
lations.
Skip steps 10–12 if the oil filter cartridge is
G
not being replaced.
10. Remove the oil filter cartridge with an oil
filter wrench.
Periodic maintenance
1. Oil filter cartridge
NOTE:
An oil filter wrench is available at a Yamaha
dealer.
11. Apply a thin coat of engine oil to the O-
ring of the new oil filter cartridge.
12. Install the new oil filter cartridge with an
oil filter wrench, and then tighten it to the
specified torque.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lb)
13. Install the engine oil drain bolts, and then
tighten them to the specified torques.
Tightening torques:
Engine oil drain bolt (crankcase):
10 Nm (1.0 m·kgf, 7.2 ft·lb)
Engine oil drain bolt (oil tank):
16 Nm (1.6 m·kgf, 11 ft·lb)
14. Add 2.0 L (2.1 US qt) (1.8 Imp.qt) of the
recommended engine oil to the oil tank,
and then install and tighten the oil filler
cap and the cylinder head cap.
51