Bnc Port - 3Com XLPCI User Manual

1-6 C
HAPTER

BNC Port

Follow these steps to connect the BNC port on the
COMBO NIC to the network:
1 Connect the BNC connector on the thin Ethernet
coaxial cable to the BNC port on the NIC. See
Figure 1-4.
Figure 1-4 Connecting to the BNC Port on the 3C900B-COMBO NIC
2 Connect the other end of the network cable to
another PC or a 50-ohm terminator.
If your PC is the last physical device in the network daisy
chain, you must connect a 50-ohm terminator to the other
end of the BNC T-connector.
The next step is to install the network driver. Go to the
next chapter.
1: I N
NSTALLING THE
BNC port
I C
ETWORK NTERFACE
BNC connector
ARD