Changing Ranges And Protocols - 3Com XLPCI User Manual

B-4 A
PPENDIX

Changing Ranges and Protocols

Follow these steps to change PACE ranges and protocols:
1 Place the cursor in the Range Start entry box and
enter a port or socket start range for the application.
2 Place the cursor in the Range End entry box and enter
a port or socket end range for the application.
3 In the Protocol selection box, click the down arrow to
display a list of the installed protocols on your PC.
4 Select the appropriate protocol for the application.
Refer to the application's user guide for the
recommended protocol.
Some applications support multiple protocols and use
different port or socket ranges for each protocol. If the
application in question uses multiple protocols, the range
and protocol must match those on your PC.
For example, if TCP/IP is the only protocol installed on your
PC, do not enter the socket range for the IPX protocol. Use
the range for TCP/IP.
5 Click Add.
The range appears in the list box.
To remove a range, select the range in the list box and
click Remove.
6 Click OK to return to the 3Com DynamicAccess Setup
screen (Figure 4-4).
B: C A
ONFIGURING DVANCED
PACE O
PTIONS