Rear Wheel - Yamaha TT-R250 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Rear wheel

To remove the rear wheel
1
WARNING
2
G
It is advisable to have a Yamaha
dealer service the wheel.
3 G Securely support the machine
so that there is no danger of it
falling over.
4
1. Remove the axle nut cotter pin,
5
and then loosen the axle nut.
2
6
7
1
8
9
1. Axle nut cotter pin
2. Axle nut
2. Lift the rear wheel off the ground
according to the procedure on
EAU25080 page 6-31.
3. Remove each swingarm end cover
by removing the screws.
EAU25280
EWA10820
1
2
(×2)
1. Swingarm end cover
2. Screw
4. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
(×2)
2
(×2)
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the rear wheel
NOTE:
Make sure that there is enough space
6-33
5. Remove the wheel.
1. Install the wheel.
ECA11070
EAU25630