Yamaha TT-R250 Owner's Manual page 46

2
(×3)
1
1. Oil filter element
2. O-ring
7. Check the O-rings for damage and
replace them if necessary.
8. Clean the oil filter element with sol-
vent, and then install it.
NOTE:
Check the oil filter element for damage
and replace it if necessary.
9. Install the oil filter element cover by
installing the bolts, then tightening
them to the specified torque.
PERIODIC MAINTENANCE AND MINOR REPAIR
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
NOTE:
Make sure that the O-rings are properly
seated.
10. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
11. Install the engine oil filter element
drain bolt, and then tighten it to the
specified torque.
Tightening torques:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14.5 ft·lbf)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
12. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
6-10
Recommended oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
1.10 L (1.16 US qt) (0.97 Imp.qt)
With oil filter element replacement:
1.20 L (1.27 US qt) (1.06 Imp.qt)
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
2
ECA11620
3
4
5
6
7
8
9