Yamaha TT-R250 Owner's Manual page 68

the wheel hub so that the projec-
tions mesh with the slots.
1. Tripmeter gear unit
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the tripmeter gear unit fits over the re-
tainer on the fork leg.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
1. Retainer
2. Wheel axle
3. Wheel axle holder nut
3. Insert the wheel axle, and then
tighten it to the specified torque.
Tightening torque:
Wheel axle:
58 Nm (5.8 m·kgf, 42 ft·lbf)
4. Tighten the wheel axle holder nuts
to the specified torque.
NOTE:
Tighten the upper nuts first, and then
the lower ones. When the nuts are
tightened in this sequence, there
should be a gap at the bottom of the
axle holder.
3
(×4)
1. Upper nut
2. Lower nut
3. Gap
6-32
1
Tightening torque:
Wheel axle holder nut:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
5. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
6. Connect the tripmeter cable.
2
3
2
3
4
5
6
7
8
9