Table of Contents
Advertisement
Scanning from PaperPort
92
You can now move or resize the outline to select the specific
area you want to scan.
2. To move the dotted outline, put the pointer in the selected area
and drag the mouse.
3. To resize the selected area, put the pointer on a dotted line and
drag it.
Note that as you drag a dotted line, the menu selection for the
image size changes to Custom to indicate you are customizing
the size.
The Scan Info box on the lower left portion of the Advanced
Interface shows the information for the new area.
4. If the dotted line is not exactly where you want it, put the pointer
on the line and drag the mouse.
5. If you want to remove the selected area and start over, click
Remove on the Scan Info box.
NOTE:
Clicking Remove causes the entire 8.5" x 14" area to be
selected.
The ruler units
The ruler around the edges of the image help you precisely
position a custom sized image. You can change the ruler units to
suit the type of measurements you want.
To set the ruler units:
1. Click the Ruler Units button.
The ruler units across the top and down the side of the window
cycle through centimeters, inches, and pixels.
The Scan Info Box
The following figure shows the information on the Scan Info box:
Location of the top
left corner of the
image in the
Preview window
Current location of
the pointer as you
drag it on the
Preview window
Physical size of the
image to scan
Size of the file of the
scanned image
The space on your
computer's hard drive
DocuMate 272 Scanner User's Guide
Advertisement
Table of Contents
Troubleshooting
