Weslo WCTL29607.0 User Manual page 10

9. With the help of a second person, hold the
Console (91) near the Right Upright (54).
Remove the wire tie from the Wire Harness (39)
and the console wire. Connect the Wire Harness
to the console wire. See the inset drawing.
The connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON. Insert the con-
nectors and the excess wire downward into the
Right Upright (54).
10. Set the Console (91) on the Uprights (53, 54).
Make sure that no wires are pinched. Start
four M8 x 15mm Bolts (8) with four M8 Star
Washers (5) into the Uprights as shown. Do not
tighten the Bolts yet.
11. Start two M8 x 15mm Bolts (8) with two M8 Star
Washers (5) into the Uprights (53, 54). Then,
firmly tighten all six Bolts from steps 10 and
11.
With the help of a second person, carefully
lower the Uprights (53, 54) to the floor.
9
Console Wire
39
54
10
91
8
5
54
11
8
5
8
10
91
39
8
5
53
53
8
8 5
54