Assembly - Weslo WCTL29607.0 User Manual

2 1/2" Bolt (56)–4

ASSEMBLY

2 3/4" Bolt (47)–4
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
4" Bolt (120)–2
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys
adjustable wrench
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses
shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preat-
tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic
parts, do not use power tools for assembly.
19mm Tek
Screw (26)–6
M5 Star
Washer (7)–2
M8 Star
Washer (5)–6
M10 Star
Washer (9)–2
1. Make sure that the power cord is unplugged.
Place a piece of cardboard under the tread-
mill frame to protect the floor during assem-
bly.
Have a second person hold the Base (52) in the
position shown.
Attach six Base Pads (63) to the Base (52) with
six 19mm Tek Screws (26).
, and your own Phillips screwdriver
, and needlenose pliers
16mm Screw 18mm Screw (58)–2
(85)–2
M6 Flat
Washer (32)–4
M10 Flat
Washer (14)–2
M8 Nut (46)–2
M8 Flat
Washer (72)–4
M6 Nut (43)–4
Star Washer (81)–4
Ground Screw
(84)–1
.
19mm Screw (10)–4
M8 x 52mm Bolt (82)–2
M6 x 58mm Bolt (13)–4
M10 x 58mm Bolt (2)–4
M10 x 110mm Bolt (1)–2
1
26
63
52
Wheel Housing Bolt (13)–4
6
Washer (29)–4
Handrail Washer (11)–
,
M8 x 15mm
Bolt (8)–6
26
63
26
26
63
26
63
63