Connect To The Amplifier With Digital Signal Input Terminal; Connecting The Ac Power Cord - VIETA VHC200 Owner's Manual

Terminal board for the DVD player
Terminal board for the
assistance equipment

Connect to the amplifier with digital signal input terminal

Terminal board for the DVD player
With digital signal input terminal's
Dolby Digital signal decode
amplifier terminal board

Connecting the AC Power Cord

1506D-e(#EJS89S,re-11)-1.p65
This unit also has a group of audio output terminals,
you can use signal line to connect this unit's audio
output terminal and assistance equipment's audio in-
put terminal respectively, then you can output the outer
sound sources to other assistance equipment.
Use coaxial signal wire to connect coaxial output jack
of the DVD player with coaxial input jack of other amplifier,
then you can feel the super digital sound effect.
1. With the unit unplugged from the mains connect the power
control cable to the DVD player and the amplifier via the
connections on the rear of the units as shown .
2. Insert the AC power cord into a wall outlet, and your system is
at your command!
Caution:
Be sure to unplug the power cord from the outlet when going
away or when the system is not in use for an extended period of
time.
- 5 -
5 2009-10-27, 11:05