Related Manuals for Zanussi ZI 9454A
Summary of Contents for Zanussi ZI 9454A
- Page 1 FRIGORIFICO- CONGELADOR FRIDGE-FREEZER REFRIGERATEUR- CONGELATEUR TWEEDEURS- KOELKAST ZI 9454A LIBRO DE INSTRUCCIONES INSTRUCTION BOOKLET MODE D’EMPLOI GEBRUIKSAANWIJZING 2223 214-24...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Environment Protection
Installation Environment Protection • During normal operation, the condenser and compressor at the back of the appliance heat up This appliance does not contain gasses which considerably. For safety reasons, minimum could damage the ozone layer, in either its ventilation must be as shown in the instructions. refrigerant circuit or insulation materials. -
Page 4: Operation
CONTENTS Warnings ................17 Use - Cleaning the interior - Use of the freezer - Control panel . -
Page 5: Temperature Indicator
D. Temperature indicator Freezing fresh food During normal functioning the indicator shows the To freeze fresh food, press the Auto freeze button (I) temperature inside the freezer. at least 24 hours before. Place the food to be frozen in the Auto freeze compartment. -
Page 6: Freezer Compartment
Freezer compartment • If food is to be frozen immediately after having installed the appliance or after a prolonged period out of use, push the button and allow the appliance to run for at least 4 hours before placing the food in it. If the freezer is already operating, with food inside it, push the button 24 hours before loading food to be frozen. -
Page 7: Use Of The Refrigerator
Use of the refrigerator Control Panel ON/OFF light Temperature setting button (coldest) Fridge button ON/OFF Auto fresh light Temperature setting button (warmest) Auto fresh button Temperature indicator J. Light ON/OFF Attention! K. Button ON/OFF Difference between the temperature displayed and Press the button (K). -
Page 8: Refrigerator Compartment
Refrigerator compartment For proper opening and closing, it is advisable to act on both doors simultaneously (as shown in the figure). • Do not place hot food or drinks in the refrigerator; wait until they trave cooled to room temperature. •... -
Page 9: Maintenance
MAINTENANCE Before carrying out any maintenance operations, including those described in this book, unplug the appliance from the mains supply. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periodic cleaning Clean the inside of the appliance and the accesso- ries with a solution of lukewarm water and bicar-... -
Page 10: Troubleshooting
TROUBLESHOOTING If something is not working properly, make sure that all the instructions in this book trave been followed before calling the SERVICECENTRE. The compressore are not working • Power cut or power supply problem. • Mains On/Off switch in position “0”. The interior lights are not working •... -
Page 11: Installation
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. -
Page 12: Height Adjustment
POSITIONING Height adjustment The height of the appliance is adjustable from 820 to 870 mm to fine up with existing kitchen units. Before installing the appliance between unite, adjust the height of the feet and rear wheels. The wheels are factory set for a height of 820 mm. To align the appliance to a height of 870 mm, raise it by adjusting the feet with a spanner, then remove the wheels and refit them in the lowest position. -
Page 13: Fitting The Door Panels
Fitting the door panels • Perforate the doors as in the drawing and insert the two screws in the bag (do not tighten them all the way down) for doors. • Before installing the doors, carefully level the appliance. • Open one of the two lower doors and insert the screws that had previously been positioned inside the slot on the hinge and on the adjustment plate. - Page 14 • Check horizontal alignment of the doors and, if necessary, correct their position by moving them along the slots. • Open the door. Adjust the planarity of the doors by means of the adjustment bushings and the lower square. • Once the doors are perfectly and completely aligned, fix a clamp screw inside the bushings (upper and lower hinge) on the lower bracket.
-
Page 15: Fitting The Plinth
Building the appliance in • Fit the appliance into the recess. • Rotate the bracket of 180° in order to obtain the right position ( 2). The position (1) is on the delivery. • Fix it to the wali with the appropriate bracket. •... - Page 16 • If using a 100 mm plinth, fit the complete height compensation strip. Alignment height of 870 mm • If using a 190 to 220 mm plinth, make a shown. • If using a plinth higher than 150 mm but less than 190 mm, cut the height compensation strip supplied with the appliance to the required depth and fit it between the plinth and the ventilation...
- Page 17 DECLARATION OF GUARANTEE TERMS Our appliances are produced with the greatest of care. However, a defect may still occur. Our consumer services department will repair this upon request, either during or after the guarantee period. The service life of the appliance will not, however, be reduced as a result. This declaration of guarantee terms is based on European Union Directive 99/44/EC and the provisions of the CE Civil Code.
- Page 18 These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e.g.: voltage, frequency, installation instructions, type of gas, etc.) for the country concerned, and that they can withstand the local climatic and environmental conditions.