System Password Change - Siemens Gigaset WLAN Operating Instructions Manual

System Password Change

After installation, your Gigaset WLAN Repeater configuration is protected with the
default password admin. To prevent unauthorised changes to the configuration, you
should set a different password and change it from time to time (see page 75).
ì
Enter the current password in the Current password box. The factory setting is
admin.
ì
Enter a password in the New password box and repeat it in the box underneath.
The password may contain up to 12 characters. The password is case sensitive.
Avoid proper names and all too obvious words. Use a combination of letters, num-
bers and special characters.
Please remember:
If you ever forget the password you will have to reset your Gigaset WLAN Repeater to
the factory settings using the reset button (see page 102). Please bear in mind that
this will restore all the settings to the factory configuration. The password will then
be admin again.
ì
Click on Next.
Security Setup
65