Testing The Dns - IBM XIV User Manual

v
v
v
v
v
v
v
v
v
Example:
Output:
Access Control:
Completion Codes:
v UNRECOGNIZED_CONFIG_PARAMETER
v READ_ONLY_CONFIG_PARAMETER
v IPV4_NOT_CONFIGURED

Testing the DNS

Tests the DNS (Domain Naming Service).
system_name - Name used as the sender's name when sending email messages.
defaultuser - Default user to be used if no user is specified for the CLI. If null, a
user must be specified.
snmp_sysname - SNMP system name as shown in the SNMP MIB.
(.1.3.6.1.2.1.1.5.0)
snmp_location - SNMP location as shown in the SNMP MIB. (.1.3.6.1.2.1.1.6.0)
snmp_contact - SNMP contact as shown in the SNMP MIB. (.1.3.6.1.2.1.1.4.0 )
email_subject_format - Controls the formatting of the email subject line. The tags
{severity}, {description} and {system_name} can be used to insert the event's
data. System default is "{severity}: {description}".
ntp_server - IP address or DNS name of the NTP server.
snmp_community - community used for SNMP queries of the system.
snmp_trap_community - community used for SNMP traps sent by the system.
config_set name=dns_secondary value=10.0.0.119
Command completed successfully
User Category
Storage administrator
Storage integration administrator
Application administrator
Security administrator
Read-only users
Technicians
Unrecognized configuration parameter: 'argument'.
Troubleshooting: Use a valid configuration parameter as an input.
Configuration parameter: 'argument' is read-only.
Troubleshooting: You cannot modify read-only parameters.
IPv4 address is not configured on management interface
Troubleshooting: Define IPv4 addrress for management before disabling IPv6
dns_test name=Name [ type=<A|AAAA> ]
Permission
Allowed
Disallowed
Disallowed
Disallowed
Disallowed
Allowed
Chapter 9. System Management
139