Tannoy POWER V6, POWER V8, POWER V12, POWER V12HP Owner's Manual page 12

9.0 TECHNICAL SPECIFICATIONS (CONTINUED)
SYSTEM
System Type
Frequency Response (-3dB)
Lowpass Filter A on
Frequency Response (-3dB)
Lowpass Filter B on
Frequency Response (-10dB)
Lowpass Filter A on
Frequency Response (-10dB)
Lowpass Filter B on
Rated Maximum SPL
Driver Complement
Crossover
Distortion
10% Full Power (12.7V)
40Hz
100Hz
1% Full Power (4V)
40Hz
100Hz
Notes
1. Average over stated bandwidth. Measured at 1 metre on axis.
2. Unweighted pink noise input, measured at 1 metre in an anechoic chamber
A full range of measurements, performance data, and Ease!" Data can be downloaded from www.tannoy.com Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or exceed the published specifications, which Tannoy reserves the right to alter without prior
CONSTRUCTION
Enclosure
Finish
Connectors
Controls & Indicators
Fittings
Dimensions
Weight
ELECTRONICS
Maximum signal input for clip
Output noise
Efficiency
Damping Factor
Distortion
Input Impedance
Protection systems
Over Current
Temperature
Brownout
Mains
Indicators
Number of channels
System Type
PSU SPECIFICATIONS
Input Connector
Voltage Selection
Type
Efficiency
Input voltage
Mains fuse
Fuse type
Other features
12
Power Vs10BP
Subwoofer-Bandpass
1 37Hz - 80Hz
1 37Hz - 110Hz
1 32Hz - 80Hz
1 32Hz - 110Hz
118dB (average) 124dB (peak)
1 x 250mm (10") High excursion bass driver
User Selectable LPF
2nd Harmonic 3rd Harmonic
2.27% 0.73%
1.79% 1.27%
2nd Harmonic 3rd Harmonic
0.57% 0.47%
0.61% 1.37%
50 litre Bandpass, 15mm (5/8) birch plywood. Internally braced.
Textured Black or White paint (Custom colours on request).
1 x female XLR (input), 1 male XLR (link), 1 x Neutrik Powercon
Level Control
Power LED (Blue)
Signal LED (Green)
Limit LED (Red)
Full Range / HighPass Switch (110Hz)
Power Switch
2 x Blanking plates, this allows the bass ports to be moved to another facia
8 x M10 Flying inserts
2 x recessed carrying handles
Blanking plate for optional VTH, pole mount
4 x Rubber Feet
335 x 365 x 590mm
14 x 14.4 x 23.25"
18kg (39.6lbs)
Input attenuator at minimum - +18dBu
Input attenuator at Maximum - +5dBu
-105dB unweighted, referenced to maximum output (22kHz bandwidth)
>90% typically
400 ref 8 Ohms
<0.05% @ 1kHz -3dB output (22kHz bandwidth)
5.6kOhms unbalanced, 11.2kOhms balanced
Excessive over current causes shutdown
Limiters applied
Automatic protection & recovery
Inrush current limiting
1x Limit LED, 1x Signal LED & 1x Power LED
one
Class D
Locking Neutrik Powercon
Automatic (115 / 230V, 45 - 65Hz)
High current, high freq. switch-mode
>90% typical
100V / 115V / 230V nominal +/-10%
External
T10AT
Automatic soft-start
Power Vs15BP
Subwoofer-Bandpass
47Hz - 80Hz
47Hz - 110Hz
37Hz - 80Hz
37Hz - 110Hz
124dB (average) 130dB (peak)
1 x 380mm (15") High excursion bass driver
User Selectable LPF
2nd Harmonic 3rd Harmonic
0.65% 0.67%
3.05% 0.70%
2nd Harmonic 3rd Harmonic
0.13% 0.30%
0.76% 0.24%
100 litre Bandpass, 15mm (5/8") birch plywood. Internally braced.
Textured Black or White paint (Custom colours on request).
1 x female XLR (input), 1 male XLR (link), 1 x Neutrik Powercon
Level Control
Power LED (Blue)
Signal LED (Green)
Limit LED (Red)
Full Range / HighPass Switch (110Hz)
Power Switch
2 x Blanking plates, this allows the bass ports to be moved to another facia
8 x M10 Flying inserts
2 x recessed carrying handles
Blanking plate for optional VTH, pole mount
4 x Rubber Feet
665 x 440 x 440mm
26.18 x 17.3 x 17.3"
30kg (66lbs)
Input attenuator at minimum - +18dBu
Input attenuator at Maximum - +5dBu
-105dB unweighted, referenced to maximum output (22kHz bandwidth)
>90% typically
400 ref 8 Ohms
<0.05% @ 1kHz -3dB output (22kHz bandwidth)
5.6kOhms unbalanced, 11.2kOhms balanced
Excessive over current causes shutdown
Limiters applied
Automatic protection & recovery
Inrush current limiting
1x Limit LED, 1x Signal LED & 1x Power LED
one
Class D
Locking Neutrik Powercon
Automatic (115 / 230V, 45 - 65Hz)
High current, high freq. switch-mode
>90% typical
100V / 115V / 230V nominal +/-10%
External
T10AT
Automatic soft-start