Assembly; Drive Shaft/Power Head; Throttle Linkage And Ignition Leads - Echo BRD-280 Operator's Manual

Bed redefiner

Hide thumbs Also See for BRD-280:

Table of Contents

BRD-280

ASSEMBLY

Parts Required:

Power Head, Drive Shaft Assembly

1. Stand power head upright on a level surface.

2. Loosen the drive shaft clamp bolt (A) at engine drive shaft

clamp.

3. Remove dust cap and carefully fit drive shaft assembly to

engine making sure that inner drive shaft engages into

clutch mount.

Note: Gear Housing must be aligned properly with engine.

4. Tighten drive shaft clamp bolt (A) securely.

5. Route throttle linkage and ignition lead assembly below fan

housing.

1. Close choke and remove air filter cover.

2. Place inner throttle cable in large hole of carburetor swivel

(A).

3. Loosen nuts (B) and place threaded end of throttle linkage

in bracket slot. Finger tighten nuts (B).

4. Check throttle for freedom of movement and that wide open

throttle / low idle extremes are adjusted properly. If

adjustment cannot be achieved with adjusting nuts (B),

consult with your Echo Dealer for correct adjustment

procedure. Tighten nuts (B).

5. Connect 2 ignition stop leads (C,D) from throttle cable

tubing to 2 ignition leads (C,D) on engine.

X7502311208

ASSEMBLY

Table of Contents