Table of Contents
Advertisement
10
A
SSEMBLY
/
DRIVE SHAFT
Tools Required: 4 mm Hex Wrench
Parts Required: Power head, Drive Shaft Assembly
1.
Stand power head upright on a level surface.
2.
Loosen the two (2) drive shaft clamp bolts at engine drive shaft
clamp, and remove center drive shaft location bolt (A).
3.
Carefully fit driveshaft assembly to engine making sure that
inner drive shaft engages into clutch mount.
4.
Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
NOTE
Gear Housing must be aligned properly with engine. Aligning
center locating hole in driveshaft housing with center drive shaft
bolt (A) provides correct alignment.
5.
Tighten two (2) drive shaft clamp bolts (B) securely.
THROTTLE LINKAGE AND IGNITION LEADS
Tools Required: 8 x 10 mm Open-end Wrench
Parts Required: None
1.
Unscrew air filter cover knob and remove cover.
2.
Place inner throttle cable in slot of carburetor swivel (B).
3.
Loosen nut (A) and place threaded end of throttle linkage on
carburetor. Finger tighten nut (A).
4.
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. If adjustment
cannot be achieved with adjusting nuts, consult with your Echo
Dealer for correct adjustment procedure.
5.
Connect 2 ignition leads from throttle cable tubing to 2 ignition
leads(C) on engine. Gather iginition wires, and position behind air
filter case.
6.
Install air filter and cover.
POWER HEAD
A
A
B
B
C
A
B
C
Advertisement
Table of Contents
